Got a Broken Garage Door Spring? Here’s What You Need to Do

Your garage door springs serve as the core of your automated door. Broken springs can occur in any residential or commercial garage door, in many cases leaving them in an inoperable condition.

When your garage door spring breaks, it could lead to greater issues like home intruders and theft. So when it does happen, you’ll have to replace it.

Read on to learn more about what you can do if you have a spring broke on garage door.

 

Move Your Car Outside

If you have a broken garage door spring, the first thing you need to do is move your car out of the garage. Once your car is out of the garage, you can start working on fixing the door. This makes it easy for you to check on the broken spring and see what you can do.

Make Sure to Have the Right Tools

Tools will vary depending on the type of garage door spring you have. However, you will need a good pair of pliers, a tension wrench, and a socket set. You may also need a screwdriver, a hammer, and a few other tools depending on the make and model of your garage door.

Remove the Broken Springs on Garage Door

You need to identify which type of spring it is. There are two types of springs, torsion springs, and extension springs.

1. Torsion Springs

A torsion spring is a type of spring that works by twisting or torquing. The amount of twist is what gives the spring its force. The more turns in the spring, the greater the force. Torsion springs are used in a variety of applications, including garage doors, clock springs, and drawer slides.

2. Extension Springs

Extension springs are a type of garage door spring that helps to open and close the door. The spring is mounted on the outside of the door and provides the tension that is needed to open and close the door.

Once you have identified the broken spring, disconnect the spring from the door. This can be done by disconnecting the cables that hold the spring in place.

Finally, you need to remove the spring from the tracks. This can be done by using a screwdriver to remove the brackets that hold the spring in place. Once the spring is removed, you can dispose of it properly.

Install the Replacement Spring

Replacing a broken spring on garage door is a relatively easy repair that you can do yourself with just a few tools. Install the new spring in the same way you removed the old one, making sure to wind it in the correct direction. Make sure all the brackets and the screw are fixed.

Check Functionality for Safety

Once you’ve got your new garage door spring installed, the first thing you’ll want to do is check it for functionality and safety. Make sure that the door opens and closes smoothly, and that there’s no obvious damage to the new spring itself. If everything looks good, then you’re all set!

However, if you are not confident in the DIY steps, you may contact a pro service whose expertise is on garage doors.

 

Never Delay Replacement if a Spring Broke on Garage Door

It is very important to never delay replacement if a spring broke on garage door. This could cause further damage to the door and frame, and even cause injury. If you notice that a spring is broken, you can simply follow the steps above.

To learn more home maintenance tips and other good reads, visit our blog posts.

Leave a Reply

Your email address will not be published. Required fields are marked *